Category: Radio
-
Programming Tait TP9300 with a mixture of analogue & digital Channels
Just like with the Motorola Portables the TP9300 handhelds can be programmed with a mixture analogue and digital if the following is observed. The TP9300 can handle a maximum of […]
-
Programming digital Motorola radios on site using CPS2.0
Programming digital Motorola radios on site using CPS2.0 This training section is meant only for CPS. If you are programming via RM, then the following does not apply. Sometimes onsite […]
-
Changing the IP Address on a TN9300 Tait Node
Before you start you will need the following: A USB Keyboard. A Monitor with a VGA input A VGA Cable Connect the monitor to the VGA port on the server […]
-
Programming Radios on RM
To access RM You need to be on the FOG Network. If RM has just been installed, you’ll need to add the server address “rm2.ct-networks.com” and port “443”. The main […]
-
-
-
-
-
-
Tait TB7100 Radio Base TX-RX Sync
The Tait TB7100 radio base works as a half-duplex line connected base when in constant Tx.
-