Author: Alex Bond
-
Programming Tait TP9300 with a mixture of analogue & digital Channels
Just like with the Motorola Portables the TP9300 handhelds can be programmed with a mixture analogue and digital if the following is observed. The TP9300 can handle a maximum of 16 channels per Zone. LCP, CAP+ and Capacity MAX are not supported by TP9300 handhelds as these are Motorola technologies. Configure the networks First you…
-
Programming digital Motorola radios on site using CPS2.0
Programming digital Motorola radios on site using CPS2.0 This training section is meant only for CPS. If you are programming via RM, then the following does not apply. Sometimes onsite there will be a situation that you will be required to reprogram a fleet of radios. This guide is designed to inform you as too…
-
Changing the IP Address on a TN9300 Tait Node
Before you start you will need the following: A USB Keyboard. A Monitor with a VGA input A VGA Cable Connect the monitor to the VGA port on the server and the keyboard to the USB socket to the front of the machine. You’ll then be prompted to login. Enter the following and you should…
-
Programming Radios on RM
To access RM You need to be on the FOG Network. If RM has just been installed, you’ll need to add the server address “rm2.ct-networks.com” and port “443”. The main screen lists every DP radio enrolled on RM. If this is a fresh install it’s a good idea to re organise the columns and put…
-
