-
Nimbra 680 Default IP and password
The Nimbra 680 is the standard IP transport system used by NEP Connect to send video and IP over the AnyLive network
-
Protected: Lynx Technik – Yellobrik – Site Feedback
There is no excerpt because this is a protected post.
-
Resetting Redundant Riedel Artist CPU Cards
When Artist CPU cards are used as a redundant pair, the card in slot A applies settings to the card in slot B which makes it difficult to reset as […]
-
Luminex 10-port Switch Fails to Power Bolero Antenna on PoE
Issue reported by Leigh Reeve, November 2019. Symptoms: Bolero antenna is not getting POE from the Luminex switch. No POE LED active on antenna and you are forced to use the PSU […]
-
MediorNet Firmware and MediorWorks
Since the release of firmware 6.00.00 you have required an approved Riedel login to download firmware and software for Riedel products. The process of signing up and the account being […]
-
-
CT London’s Default Barco E2/S3 Frame Configuration
Barco E2 – Gen1 frame: Barco E2 – Gen2 frame: Barco S3 frame:
-
Setting the WAN IP of the UniFi Security Gateway
The UniFi system is a cloud managed service where all settings are controlled by the UniFi Controller. To access these settings all the Ubiquiti devices need access to the internet, […]
-
Panasonic Projectors Default Passwords and Control Software
Panasonic GeoManager Software / Manual is available here. Panasonic Multi Monitoring & Control Software / Manual is available here. Panasonic Projector Network Setup software / Manual is available here. Panasonic […]
-
PlayBack Pro Only Supports ProRes
PlayBack Pro is only designed to work with ProRes files. Although it has been proven to work with H.264 .mov and .mp4 files, it is not supported by DT Videolabs […]
-
Straight Alpha vs Premultiplied Alpha
Some people insist premultiplied alpha is the way to go, some say straight alpha. To be frank, both are equal in most situations as long as the math and compositing […]
-
Makito X Factory Reset
The Makito X encoder and decoders can be factory reset if they’re inaccessible. To the left of the network port there is a hole for a reset button. Hold the […]
