Author: Alem Dzinic
-
R&D: Chromecast/Apple TV 4K into Barco S3/E2 system
Test performed: 10 October 2019 Chromecast Connecting Chromecast into the E2/S3 on HDMI 1.4 connector shows up in EMT as a valid signal but you can see black picture only. […]
-
Lightware MX4x4DVI / MX8x8DVI Factory Default Reset Procedure
UPDATE 10.10.2019 – MX 4×4 DVI doesn’t reset by following below procedure. The MX4x4 DVI will not factory reset via the button config, there is no way to ‘Factory reset’ […]
-
Barco CXP Links Test
If the links between the E2/S3/Ex frames are not behaving or there are resource errors then a good place to start is checking the link cables between your frames. On […]
-
Protected: R&D: Latency: Blackmagic BiDirectional HDMI/SDI Micro converters
There is no excerpt because this is a protected post.
-
Riello UPS VSD 3000 Alarm / Fault Codes
Riello UPS report faults and alarms using a code on their display. The codes can be found here.
-
Barco Event master EX expansion unit – IP address configuration
To obtain IP address and Unit ID of the EX frame you need an USB thumb drive formatted as FAT32 file system and a computer running Event Master Toolset app. […]