How to Control Barco E2 Presets from a Pixera Timeline Cue

Open Pixera and go to the Control tab.

From the Library on the left hand side drag a “NewModule” to the Project window containing the Pixera module by default.

Select the NewModule in the Project window and, in the inspector properties on the right hand side, change the name. For example call it “SENDER”.

Drag from the library  “EventMaster” module to the Workspace.

Select “Eventmaster” module and in the properties on the right hand side set the IP address of the Barco Event Master frame.

Select the module named “SENDER”, press right hand mouse click within the module and click on add action, then name it “SendCue1”.

Select action “SendCue1” and in the inspector click on the “Code” tab.

First click on the button above to enable Edit-mode.

Next, click on the button above and select “Eventmaster” module from the dropdown list for which you want to use an action.

Then click on the plus symbol to add the action, select “Preset”, then “PresetToPGM” and type in the number of you preset.

Don’t forget to save the action by click on the symbol with an arrow pointing down.

Go to the Pixera Timeline tab.

Add a cue on the timeline where you would like Event Master frame to be trigged.

Select the cue and adjust the network command in the inspector, on the right hand side of the screen, as per the screenshot below.

Add an action in the “SENDER” module in Control tab for each preset you would like to trigger from the timeline  and repeat the setup for each action.

In the future there will be a way to pass a number from Timeline  cue to the  Control without creating an action for every preset in the “Sender” module.